Original topic:

#GalaxyTechfluencer

(Topic created on: 04-15-2020 07:02 PM)
148 Views
Narayanmk
Expert Level 5
Options
Tech Talk
Carrier Aggregation is a technology to combine two or more carriers into one data channel to enhance the data capacity. It is possible to combine carriers in the same or different frequency bands.Carrier aggregation is used in LTE-Advanced in order to increase the bandwidth, and thereby increase the bitrate. Since it is important to keep backward compatibility with R8 and R9 UEs the aggregation is based on R8/R9 carriers. Carrier aggregation can be used for both FDD and TDD, see figure 1 for an example where FDD is used.

image

Each aggregated carrier is referred to as a component carrier, CC. The component carrier can have a bandwidth of 1.4, 3, 5, 10, 15 or 20 MHz and a maximum of five component carriers can be aggregated, hence the maximum aggregated bandwidth is 100 MHz. In FDD the number of aggregated carriers can be different in DL and UL, see figure 1. However, the number of UL component carriers is always equal to or lower than the number of DL component carriers. The individual component carriers can also be of different bandwidths. For TDD the number of CCs as well as the bandwidths of each CC will normally be the same for DL and UL.

The easiest way to arrange aggregation would be to use contiguous component carriers within the same operating frequency band (as defined for LTE), so called intra-band contiguous. This might not always be possible, due to operator frequency allocation scenarios. For non-contiguous allocation it could either be intra-band, i.e. the component carriers belong to the same operating frequency band, but have a gap, or gaps, in between, or it could be inter-band, in which case the component carriers belong to different operating frequency bands, see figure 2.


image

Thank you for your time🙏🙏🙏


mknarayan 😎😎😎😎😎


0 Comments