OptimusPrime108
Expert Level 5
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-07-2021 09:20 PM (Last edited 06-07-2021 10:13 PM ) in
Tech Talk
Hey pals, good night.
I have a Bixby routine like this:
IF <sleep detected> and <specific SSID connected>
THEN <turn off location> and <enable power saving mode>
Also, reverse the actions when the routine goes off.
However, I have noticed the Location is not turning back ON itself. Anyone facing this issue? I am using N20U.
3 Comments
Gurmeet1
Expert Level 4
Options
- Mark as New
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-07-2021 09:46 PM (Last edited 06-22-2021 06:45 PM ) in
Tech Talk
Because enable power saving mode turn off location.try without power saving mode
OptimusPrime108
Expert Level 5
Options
- Mark as New
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-07-2021 10:04 PM in
Tech Talk
Not really. I have manually turned on power saving mode but still location is on.
Gurmeet1
Expert Level 4
Options
- Mark as New
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-22-2021 06:46 PM in
Tech Talk
Try without power saving mode